EZ CREAMER Instructions

The EZ CREAMER is quickly mounted onto your work surface using the two mounting screws. All metal parts of the EZ CREAMER are stainless steel.

Cut both ends of the corn. Make sure the cut goes through all the shucks when cutting the large end.
Insert the included cob screw in your drill motor and tighten with the chuck
Screw the cob screw into the large end of an ear of corn.
Insert the corn into the EZ CREAMER's bottom tube below the brush.
Using the drill in a clockwise rotation, move the cob of corn up and down against the brushes.
The cob will soon be free of virtually all shucks and silk.
After the corn is clean, insert it into the EZ CREAMER's top tube for cutting.
Once again, run your drill in a clockwise direction until the corn is creamed. One or two times in and out is sufficient.
Reverse your drill motor to unscrew the empty cob.

Repeat the process until all your corn is creamed!

If you have questions about the EZ CREAMER from Southern Dimensions Group,
please click on this email link.
or Call us toll-free at:
888-507-8517

Click to close this window and return to the EZ CREAMER page.